http://www.touratech-usa.com/instl/instl_020-0020.html


back to:
www.touratech-usa
 

TOURATECH Mini-Roadbook holder installation tips.

part# 020-0020



Use these suggestions at your own risk.

  • These instructions are new and have not been tested by independent installers.
  • The instructions are not complete.
  • Touratech and Touratech-USA assume no responsibility for errors using these suggestions.

     

  • Synopsis

     


    1) The Roadbook Holder is designed to attach to the 12mm crossbar of a dirtbike handlebar. Can be adapted to other handlebars with the "065-0040" (=GRBH) RAM adapter. (see below)

    2) Remove the protective film to expose the shiny clear macrolon window.

    3) If desired tape the plexiglas writing surface below the paper.



    Attachment:

    Backside shown. Designed to fit on a 12mm dirtbike crossbar.


    Dimensions:

    Dimensions shown in millimeters. The 48mm set of holes is for the "065-0040" (=GRBH)



    Plexiglas EXTRA:

    Shown with the main cover removed.

    Free accessory provided by CycoActive. The plexiglas writing surface under the paper allows you to lift the cover and write on the paper.

    Tape it to the vertical chassis with electrical tape, with the beveled edges resting on the round aluminum bars. It is shown taped on one side only. Tape on one side is sufficient, you can tape both sides if desired.

     

    Touratech item # "065-0040"
    or equivalent CycoActive item # "GRBH"

    Two numbers for the same part. This allows adaption of the Mini-Roadbook holder to other handlebar styles. Also allows roadbook holder to extend higher, above a tankbag, for example. See the GRBH.

    On Touratech-USA, search for part# 065-0040


    http://www.touratech-usa.com/instl/instl_020-0020.html